Instructions / Assembly

HOW T
O INSTALL SPEEDTILES 3 x 6 GLASS MOSAICS :
1
2
Please ensure that the wall where you are installing the SpeedTiIes is CLEAN, SMOOTH, LEVELED and NON-POROUS.
S
TICKING TIP: Use a 500 ml to 750 ml bottle filled with water and add 1 to 2 tea spoon(s) of mild dishwashing liquid.
3 Then find the highest countertop point and draw a level line from that point.
This line will serve as a guide to install the first row of tiles.
4 Place the tile (pre-cut if needed) with the glass side facing the countertop and remove the Inoxia protection paper.
Spray a SMALL amount of soapy water mix on the adhesive and spread it with your hand over the whole surface. Adding soapy water will
allow you to perfectly adjust the tile on the wall by delaying the bonding time.
5
Install the tiles
according to the desired layout.
6
OPTIONAL: Once the tiles are in place, apply the grout of your choice following the manufacturer's instructions.
HOW TO CUT THE GLASS
Use a non-permanent marker to draw a cutting line.
Stick masking tape along the cutting line. The masking tape must be placed on the piece of tile that will be installed.
Cut the surface following the drawn line, according to the instructions for the tool you will be using.
Sand the cut edge (120 grade sandpaper) to soften the edge.
BEFORE INSTALLING!
It is highly recommended to inspect the tiles one by one.
If the installation is done without grout, for best results it is recommended
to previously paint the wall in a color similar to that of the tiles.
PROPOSED TOOLS FOR INSTALLATION :
- Grout float
- Glass cutter or
Manual tile cutter or
Wet tile saw with diamond blade