Installation Guide

TBA Module Installation Guide
08/11/22 357-00062-01 Rev A
- The TBA module does not contain any user serviceable components.
- A label must be affixed to the outside of the host product with the following statements:
Contains FCC ID: HCQTBA Contains IC: 2309A-TBA
FCC and Industry Canada Compliance
FCC Part 15 and Industry Canada Statements:
a. CFR 47 Part 15.19 Labeling Requirements – Host product must bear the following in a
conspicuous location on the device.
This device complies with part 15 of the FCC Rules and Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne
doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
b. Part 15.21 Information to the user – The user’s manual shall contain the following caution:
This device complies with part 15 of the FCC Rules, and any changes or modifications not
expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.
FCC and Industry Canada RF Exposure Requirements
The user’s manual for the host product must clearly indicate the operating requirements and conditions
that must be observed to ensure compliance with current FCC / IC RF exposure guidelines.
IMPORTANT: The following statements must be included in the User’s Manual:
FCC Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. In
order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the
antenna shall not be less than 20 cm during normal operation and must not be co-located or operating in
conjunction with any other antenna or transmitter. The TBA module must not transmit simultaneously
with any other co-located or transmitter, except in accordance with FCC multi-transmitter product
procedures.