User's Manual

FOR OFFICIAL USE ONLY 10
5. Emplacement Procedure
Once the Coyote UGS node has been sucessfully activated, it is ready for emplacement. The high level steps
for emplacing a Coyote UGS node after it has been activated are:
1) Connect any Sensor Accessories
2) Dig the Hole and Emplace the Coyote UGS node
3) Bury the Node and Camouflage it
5.1. Connecting Sensor Accessories and RF Antenna
To connect any external sensor accessories to the Coyote UGS node:
a) Connect the male end of the umbilical cable to port J1 on the Coyot eUGS node
b) Connect the female end of the umbilical cable to a MIDs Accessory
c) Connect the RF antenna to port A1 of the Coyote UGS node
Plug pin end into J1 receptacle on UGS
Node (a)
Plug socket end into receptacle on MIDs Accessory
Antenna port A1 (c)
PIR connect to J2 or J3 on MIDs Accessory (b)
Figure 8 - Connecting Coyote UGS antenna and accessories