User's Manual

JUNI JF43-E1900/CFN03
CDMA FIBER FED REPEATER OPERATIONS MANUAL
Version 1.17 ⓒ J
uni America Inc. Page 45 of 88
[Figure 4.6] Repeater Setup Window
Click the “Load” button to display the current configuration. To make changes to the
current settings, tick the box beside each of the desired items and click “Save” and
then “OK”. For initials setting values and instructions, please refer to section 4.2.6.3.
4.2.5 Offset Calibration
Since the power level readings can differ to the actual RF power level by up to 1dB,
an offset feature exists within the LMT that allows you to calibrate the LMT to
synchronize the readings from the RF test equipment.
The default offset values for all repeaters are set to 0. To access the offset feature, do
as shown in figure 4.4 and select “Offset” to display the window below. The process is
the same for both Donor and Remote.
[Figure 4.7] Default Offset Feature Window for Remote and Donor
To set an offset for a particular parameter, first check the CHG box to enable the LMT