User's Manual

AT20 Online Dual-spectrum Thermal Camera User Manual
13
Figure 8.2 Rear Shell Installation
8.2 Front Mounting
There are four M4 threaded holes on the front mounting bracket for
fixing.
Step 1 Install the front mounting bracket
As shown in Figure 8.3, connect the front mounting bracket and the
thermal camera with ST2.2*8 self-tapping screws. The installation
effect is shown in Figure 8.4.
Step 2 Punch holes
As shown in Figure 8.5, please paste the sticker to the position to be
installed, and then punch four Φ4.5 mounting holes according to the
label on the sticker.
Step 3 Install the thermal camera
As shown in Figure 8.5, use M4 screws to install the thermal camera
to the designated location.