User's Manual
Table Of Contents
- Table of contents
- I. Getting Started
- II. Hardware description
- III. Installation procedure
- 1. Installation preparations
- 2. InfiNet Wireless R5000-Omx/Omxb
- 3. InfiNet Wireless R5000-Lmn
- 4. InfiNet Wireless R5000-M/Mm and R5000-Smn/Smnb/Smnc
- 5. Mounting kit (MOUNT-KIT-85)
- 8. InfiNet Wireless R5000-Smnc
- II. Configuration (Web-interface)
- III. Configuration (CLI)
- IV. Link setup
- V. Lost password recovery
- VI. Recommendations
- VII. Supplementary information
39
Copyright © 2004-2012 by InfiNet Wireless
Step 1. Put the cable sealing nut (4) and the cable gland ca
se
(5) onto the cable as shown on the picture. Crimp the regular
RJ-
45 connector (3) onto the cable using the crimping tool.
Do not use the shielded RJ-
45 connector (2) on this end of
the cable as it should be attached on the IDU end.
Make sure that the RJ-45 connector is well-
crimped. A
loose connector can damage the device. Please note
that such damage is not covered by the warranty.
Step 2. Insert the connector into the socket until you hear a
click. Screw the cable gland case into the port and tight
en it.
Do not apply excessive
force.
Step 3. Tighten the sealing nut (4). Do not apply excessive force.