User Manual
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Web GUI Access
- Dashboard
- Device status
- Wired interface
- Wireless link status
- Modulation code scheme
- Modulation and coding schemes are selected independently for each channel (uplink and downlink) for both polarizations. Current modulation for each channel is displayed in the MCS subsection.
- Received signal strength indicator
- EVM
- Retries and Frame loss
- General settings
- Security settings
- Radio settings
- Network settings
- Switch Settings
- SNMP settings
- Spectrum Analyzer
- Antenna Alignment Tool
- Maintenance
- Instant DFS
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – Quanta 5 / Quanta 6
Operation & Administration – 74
•
•
•
•
•
•
•
•
•
•
•
•
Parameter Description
Dynamic
frequency
selection
Following modes are possible to operation:
Frequency selection off - the center frequency must be selected manually.
Mandatory DFS and radar detction - the least noisy frequency will be selected in
accordance with the set frequency grid. The device will block the frequency in case it detects
a radar.
Instant DFS-the least noisy frequency will be selected in accordance with the set frequency
grid. The device will change frequency in case the strong interference appears.
Instant DFS and radar detction - the least noisy frequency will be selected in accordance
with the set frequency grid. The device will change frequency in case the strong interference
appears and block the frequency in case it detects a radar.
Regulatory
domain
Regulatory domain automatically limits the wireless device operation which is may be needed to
meet the local law requirements. Each regulatory domain may limits the following parameters:
Range of available center frequencies
Requirement of use LBT (Listen Before Talk) technique.
Maximum EIRP (Equivalent Isotropically Radiated Power) value.
Requirement of use radar detection technique.
Fixed
center
frequency
Available only on the Slave unit.
Enabled - center frequency must be set manually on wich the Slave unit will operate.
Disabled - center frequenct will be selected automatically based on frequency channel grids.
Downlink/
Uplink
center
frequencies
Allows to manually set the center frequency, uplink and downlink directions can use the same
frequency or different. The uplink frequency can be configured only on the master.
Power limit This parameter limits the transmitter power, there are two modes:
Transmitter output power - limits the power of transmitter to the set value.
EIRP - limits the total system power calculated as: Tx Power + Antenna gain + Cable loss (an
antenna gain and cable losses should be specified in the fields below).
10 Radio frontend settings description
NOTE
The radar detection mode is only available with "ETSI" regulatory domain. Instant DFS
and radar detection are only available for the Quanta 5 family devices.
NOTE
Downlink - the direction from Master to Slave, Uplink - the direction from Slave to
Master. These directions are correct for the whole link and do not depend on the roles
of the devices.