User's Manual

Technical Document
CB951 Installation Guide Page 2 P/N 430697-00 Rev C
Position and Install the CB951 Access Point
Depending on the location and the ceiling type, the CB951 Access Point can be mounted on a
beam or through a ceiling tile:
• Tile/Ceiling-mounted CB951: Install the unit above the ceiling tile with the antenna and
LED barrel protruding through the ceiling tile. Verify that the LED barrel and antenna are
visible from the sales floor.
• Open-Beam-mounted CB951: Using zip-ties or hardware, attach the CB951 Access
Point to the bottom of the beam. Verify that the LED barrel and antenna are visible from
the sales floor. Try to mount the Access Point lower than nearby ducting and electrical
conduits.
Wiring
The CB951 can be wired using an RJ-45 connector, (568B standard LAN), using CAT5 Network
Cable. The CB951 must be connected using one of the following:
• P.O.E. Switch: Using a CAT5 Network Cable connect one RJ45 to the LAN port on
the CB951 Access Point. Connect the other end of the cable to an available port on
the P.O.E. switch.
• Standard Switch: Using a CAT5 Network Cable connect one RJ45 to the LAN port
on the CB951 Access Point. Connect the other end of the cable to an available port
on the switch. Connect the AC adapter to an available power outlet, connect the
other end to the DC power jack on the Access Point.
To 12VDC
Adapter
(
p
ositive ti
p
)
To network P.O.E.
switch or
Standard switch
CB951 Mounting Template
Depending on the location of the Access Point and the ceiling type, the following template may
be used to accurately mark the holes for the antenna and the indicator L.E.D. The CB951
Access Point can be mounted on a beam or through a ceiling tile.