Instruction for Use

EN
5
ON/OFF/Reset button
Pressing the button normally will cause the machine to switch on or off. If the button is pressed for 3 seconds while the dryer is in
function, the machine will switch off and the running cycle will reset.
Programme selection knob
Allows for setting the programme: turn until the indicator points towards the desired programme (see Starting and selecting a
programme).
Options buttons
Allow for selecting the options available for the selected programme. The relative indicator lights turn on when the option has been
selected (see Programmes and options).
START/PAUSE button and indicator light
When the green light flashes slowly, press the button to start the programme. When the cycle is under way, the indicator light remains
on. To put the programme into pause mode, press the button again; the indicator light will turn orange and start flashing again.
To resume the programme from the point it was interrupted, press the button again (see Start and programme selection).
Indicator lights
The indicator lights provide important information. They indicate the following:
Clean filter indicator light
Before each programme, the Clean filter indicator light
signals that it is essential to clean the filter each time before using the tumble
dryer (see Care and maintenance).
Drying phases indicator lights
The
indicator light signals that the drying phase is running.
The
indicator light signals that the cooling phase is running.
The END indicator light signals that the programme has ended.
Delay start indicator light
If the Delay start option has been activated (see Programmes and options), after the programme has started, the indicator
light corresponding to the chosen delay time will start flashing:
As time passes, the remaining delay will be displayed and the corresponding indicator light will flash:
Once the set delay time ends, the flashing LED will turn off and the set programme will start.