Instruction for Use

The following instructions are intended for a qualified fitter

to guide him/her along the installation, adjustment and

technical maintenance procedures as correctly as possible

and in full compliance with the applicable norms in force.

Important : unplug the hob before all operations.

Installation

• This hob can be built into a worktop simply by cutting

out the corresponding slot.

• The worktop must be made with a material designed

to withstand a temperature of approximately 100°C.

• The hob should be positioned at least 40 mm away

from the back wall or any other vertical surface in order

to allow for correct ventilation and to prevent the

surfaces around the appliance from overheating.

10 mm

Distance to

keep between the

cut-out slot and

the cabinet

Fastening

Very important: It is vital that you ensure the glass

ceramic hob is built into a perfectly flat supporting surface.

Deformations due to improper fastening could alter the

characteristics of the hob and compromise its performan-

ce.

The fastening springs are fastened by screws (see

diagram).

It is vital that these screws be kept accessible at all

times.

Insert the hob into the cut-out slot, applying pressure all

along the perimeter of the hob frame so that the latter

adheres fully to the worktop.

FRONT OF HOB

KITCHEN

WORKTOP

REAR SPRING ASSEMBLY

HOB FROM BELOW

Installation and fastening

560 +/- 1

490 +/- 1

590

520

560 +/- 1

490 +/- 1

574

504