Use and Care Guide
3
The basic oven must be installed on legs or mounted on a modular stand. Installations on concrete bases or
other supports restricting air circulation underneath the oven is not advisable and may void the warranty. If using
the modular stand, set the oven on the stand after unpacking.
RATING PLATE
The rating plate is located in front of the oven below the oven section. Information on this plate includes
the model and serial numbers. When communicating with factory about a unit or requesting special parts or
information, this data is essential for proper identification. Other information on this plate is the BTU/hr input of the
burners, operating gas pressure in inches W.C., and whether the unit is orificed for natural or propane gas. Pilot
lighting instructions are also located in the same area.
IMPERIAL COOKING APPLIANCES MUST BE CONNECTED ONLY TO THE
TYPE OF GAS IDENTIFIED ON THE RATING PLATE
CLEARANCES
The appliance area must be kept free and clear of all combustibles. This unit is design-certified for the
following installations only:
The clearances from combustible and noncombustible construction are as follows:
Combustible Noncombustible
Back 6” 0
Sides 6” 0
DO NOT MOUNT oven on a curb base. Use legs/casters provided. Adequate air space at the bottom and rear of
the unit must be provided for proper venting of the blower motor.
ASSEMBLY
DO NOT USE door to lift or move oven. All ovens must be installed on leg assembly or casters shipped with the
unit. The leg/stand assembly pans or casters are shipped separately.
SINGLE OVEN ICVG-1, ICVDG-1
Assemble the leg/stand assembly as follows:
1. Remove legs from the package.
2. Bolt legs directly to bottom of oven.
If provided with optional bottom shelf and rack support check instructions included in the shipment.
DOUBLE OVEN ICVG-2, ICVDG-2
6” leg assembly is provided.
1. Match holes on the legs with oven bottom base and screw with bolts provided.
2. Set top oven on bottom oven.
3. Bolt down at rear and front. Remove top kick plate to access screwing the front bolts.
CASTER INSTALLATION
If casters are provided, match holes on the caster with holes on the oven bottom base and fasten with bolts
provided. NOTE: Front casters are locking type.
LEVELING