Technical Manual

TECHNICAL MANUAL
Page n°20 of 25
RF TRANSCEIVER MODULE 2.4GHz
B033
Doc. Revision°:0
Date: 11/01/2021
Technical Manual file.dot revisione n° 0 data: 24/02/2020
IMET s.r.l. Via Ronche, 93 33077 Sacile (PN) – ITALY – Tel. [phone] – Fax [phone] P.IVA C.F. e Reg. Impr. PN:01106390931 R.E.A.
43483 CCIAA PN http//www.imet.eu e-mail: [e-mail]
A.1.1 Labelling and User Information Requirements
The B033 module has been labelled with its own FCC ID number, and if the FCC ID is not visible
when the module is installed inside another device, then the outside of the finished product into
which the module is installed must also display a label referring to the enclosed module. This
exterior label can use wording as follows:
Contains Transmitter Module FCC ID: 2AYRTB033 or Contains FCC ID:2AYRTB033 This device complies
with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation
A user’s manual for the product should include the following statement:
This equipment has been tested and found to complying with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy, and if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.