Anti-Tip Bracket Installation Guide

HOW TO INSTALL THE ANTI-TIP BRACKET
After removing the drawer, or the panel under the
door, using a ashlight, verify that the anti-tip bracket
has been installed properly.
Anti-tip bracket
A child or adult can tip the range and be killed
Install the anti-tip device to the structure and/or the
range ( see pictures for details)
Engage the range to the anti-tip device as explained
in the pictures.
Re-engage the anti-tip device if the range is moved
See pictures for details
Failure to do so can result in death or serious burns to
children or adults
WARNING
- Mark the total height on the rear wall at the centre
of the cooker width. Make two holes and install
the xing bracket.
OPTION 1: wall mounted bracket
ATTENTION: check that the cooker is leaning against
the rear wall to avoid tipping.
Fig. 4a
- Adjust the height of the xing brackets based on the
measurement made as explained above. Fix them to
the oor as shown in the picture below.
OPTION 2: oor mounted bracket
ATTENTION: in this case 2 brackets are needed
Fig. 4b
- Unpack the cooker and mount the feet and
adjust the height.
- Measure the height from the oor to the top edge
of the back-cross bar (Fig. 4) and add 15mm.
Fig. 4