Use and Care for Majestic II

BASE FEET

PRESSURE GAS REGULATOR INSTALLATION INSTRUCTION

Pressure gas regulator is supplied with the appliance. It is stored in the oven.

Legs are packed in carton box. Legs should be installed near to where the appliance is to be used, as they are

not secure for long transit. After unpacking the range, raise it about a foot to remove the bottom shipping skid.

Keep the unit raised to allow legs to be screwed into their couplings and lower it gently to keep any undue strain

from the legs and internal mounting hardware. It is strongly recommended that a pallet or lift jack be used rather

than tilting.

MAJESTIC

Fig. 1a

1) Remove the foot (A) from the cooker

and x in the foot cover (D)

2) Secure the foot cover (D) with three bol-

ts, the three washers and the three nuts (B)

into the bracket (C) which is positioned at

the rear of the kitchen

MAJESTIC LION PAW FEET

Fig. 1b

1) Insert the bolt (A) into the bracket

hole and tighten the nut (B).

2) Insert the pin between the bra-

cket and the xing support (D) and

tighten the nut (B).

PROFESSIONAL

Fig 1c

1) Screw partially bolt (F) into

the base foot (G).

2) Insert base foot (G) into the

hole (Ha), move in to the slot

(Hb) and screw completely

bolt (F).

B C

A A CB BC

Fig. 2a

As show in Figure 2a, unscrew B part from C part.

Screw C part into A part (Fig. 2a). Please use a proper gasket, for this connection.

As show in Figure 2b, screw A+C part into part B.

Fig. 2b