GB RENODLAD
ENGLISH Please refer to the last page of this manual for the full list of IKEA appointed After Sales Service Provider and relative national phone numbers.
ENGLISH 4
ENGLISH Contents Safety information Safety instructions Product description Control panel Programmes Options Settings Before first use 4 5 7 8 9 10 11 15 Daily use Hints and tips Care and cleaning Troubleshooting Technical information ENVIRONMENTAL CONCERNS IKEA GUARANTEE 16 18 20 22 26 26 26 Subject to change without notice. Safety information Before the installation and use of the appliance, carefully read the supplied instructions.
ENGLISH 5 General Safety • • • • • • • • • • • This appliance is intended to be used in household and similar applications such as: – farm houses; staff kitchen areas in shops, offices and other working environments; – by clients in hotels, motels, bed & breakfast and other residential type environments. Do not change the specification of this appliance. The operating water pressure (minimum and maximum) must be between 0.5 (0.05) / 8 (0.8) bar (MPa) Obey the maximum number of 13 place settings.
ENGLISH • Make sure that the appliance is installed below and adjacent to safe structures. • The water inlet hose has a safety valve and a sheath with an inner mains cable. Electrical connection Warning! Risk of fire and electrical shock. • The appliance must be earthed. • Make sure that the parameters on the rating plate are compatible with the electrical ratings of the mains power supply. • Always use a correctly installed shockproof socket. • Do not use multi-plug adapters and extension cables.
ENGLISH 7 Service Disposal • Contact the Authorised Service Centre to repair the appliance. We recommend only the use of original spare parts. • When you contact the Authorised Service Centre, ensure that you have the following information that is available on the rating plate. Model : PNC : Serial Number : Warning! Risk of injury or suffocation. • Disconnect the appliance from the mains supply. • Cut off the mains cable and discard it.
ENGLISH 8 Beam-on-Floor Beam-on-Floor is off when the appliance is deactivated. Beam-on-Floor is a light that is displayed on the floor below the appliance door. When AutoOpen is activated during the drying phase, the projection on the floor may not be completely visible. To see if the cycle has ended, check the control panel. • When a programme starts, a white light is on and stays on for the duration of the programme. • When the programme is completed, the white light is off.
ENGLISH 9 Programmes Programme P1 1) P2 P3 2) P4 3) Degree of soil Type of load Programme phases • All • Prewash • ExtraHygiene • Crockery, cutlery, • Wash from 45 °C to 70 • DryPlus pots and pans °C • Rinse • Dry • Heavy soil • Prewash • Crockery, cutlery, • Wash 70 °C pots and pans • Rinse • Dry • ExtraHygiene • DryPlus • Fresh soil • Crockery and cutlery • Wash 60 °C • Rinse • ExtraHygiene • DryPlus • Normal soil • Crockery and cutlery • • • • • ExtraHygiene • DryPlus Prewash Wash 50 °C R
ENGLISH 10 Consumption values Water (l) Energy (kWh) Duration (min) P1 7 - 14 0.6 - 1.6 40 - 170 P2 12.5-14.5 1.4-1.7 170-190 P3 10 0.9 41 P4 10.5 0.83 232 P5 12 - 14 0.7 - 0.9 82-92 P6 4 0.1 14 P7 9 - 10 1.1 - 1.3 230 - 250 Programme 1) 1) The pressure and the temperature of the water, the variations of the mains supply, the options and the quantity of dishes can change the values.
ENGLISH DryPlus Activate this option when you want to boost the drying performance. With use of this option, the duration of some programmes, water consumption and the last rinse temperature can be affected. The combination of DryPlus and rinse aid gives you even better drying result. The DryPlus option is a permanent option for all programmes other than P4 (ECO) and need not to be selected at every cycle. Every time P4 (ECO) is activated, DryPlus option is off and needs to be chosen manually.
ENGLISH 12 Press and hold RESET until the appliance is in programme selection mode. The water softener should be adjusted according to the hardness of the water in your area. Your local water authority can advise you on the hardness of the water in your area. It is important to set the right level of the water softener to assure good washing results.
ENGLISH • The indicators , , and are off. still flashes. • The indicator • The display shows the current setting: e.g. = level 5. 3. Press repeatedly to change the setting. 4. Press the on/off button to confirm the setting. The rinse aid dispenser The rinse aid helps to dry the dishes without streaks and stains. The rinse aid is automatically released during the hot rinse phase. You can set the released quantity of rinse aid between level 1 (minimum quantity) and level 6 (maximum quantity).
ENGLISH = the rinse aid empty notification is deactivated. 4. Press on/off to confirm the setting. Acoustic signals Acoustic signals sound when a malfunction of the appliance occurs. It is not possible to deactivate these acoustic signals. There is also an acoustic signal that sounds when the programme is completed. By default, this acoustic signal is activated and it is possible to deactivate it. In addition, an acoustic signal will sound before the AutoOpen will open the door.
ENGLISH the indicators 15 , , , and • The indicator still flashes. • The display shows the current setting: = AutoOpen activated. start flashing and the display is blank. 2. Press . • The indicators , , and are off. to change the setting: = 3. Press AutoOpen deactivated. 4. Press on/off to confirm the setting. Before first use 1. Make sure that the current level of the water softener agrees with the hardness of the water supply. If not, adjust the level of the water softener. 2.
ENGLISH 16 5 4 3 A Caution! Water and salt can come out from the salt container when you fill it. Risk of corrosion. To prevent this, after the replenishment, start a programme. Filling the rinse aid dispenser 1 2 Fill the rinse aid dispenser until the rinse aid reaches the marking "MAX". Remove the spilled rinse aid with an absorbent cloth to prevent too much foam. Fill the rinse aid dispenser when the indicator (A) becomes clear and the rinse aid indicator on the control panel is on. Daily use 1.
ENGLISH 3 4 30 30 5 1. Keep the appliance door ajar. 2. Press the on/off button to activate the appliance. Make sure that the appliance is in programme selection mode. 3. Press or repeatedly until the display shows the number of the programme you want to start. The display will show the programme number for approximately 3 seconds and next the programme duration. 4. Set the applicable options. 5. Close the appliance door to start the programme.
ENGLISH If the door is opened for more than 30 seconds during the drying phase, the running programme will end. This will not happen if the door is opened by AutoOpen. Caution! Do not try to close the appliance door within 2 minutes after AutoOpen automatically opens it, as this may cause damage to the appliance. If, afterwards, the door is closed for another 3 minutes, the running programme ends. 18 Press and hold RESET until the appliance is in programme selection mode.
ENGLISH • Detergent tablets do not fully dissolve with short programmes. To prevent detergent residues on the tableware, we recommend that you use the tablets with long programmes. • Do not use more than the correct quantity of detergent. Refer to the instructions on the detergent packaging. What to do if you want to stop using multitablets Before you start to use separately detergent, salt and rinse aid do the following procedure. 1. Set the highest level of the water softener. 2.
ENGLISH 20 Care and cleaning Warning! Before maintenance, deactivate the appliance and disconnect the mains plug from the main socket. 3 4 Dirty filters and clogged spray arms decrease the washing results. Make a check regularly and, if necessary, clean them. Cleaning the filters 1 2 C B A To remove filters (B) and (C) turn the handle counterclockwise and remove. Pull apart filter (B) and (C). Wash the filters with water. 5 Remove filter (A). Wash the filter with water.
ENGLISH Cleaning the filter of the inlet hose 1 2 A Close the water tap. Disconnect the hose. Turn the fastener A clockwise. 3 4 3. Wash the spray arm under running water. Use a thin pointed tool, e.g. toothpick, to remove particles of soil from the holes. Clean the filter of the inlet hose. Cleaning the upper spray arm We recommend to clean regularly the upper spray arm to avoid soil to clog the holes. Clogged holes can cause unsatisfactory washing results. 1. Pull out the upper basket. 2.
ENGLISH 22 External cleaning • Clean the appliance with a moist soft cloth. • Only use neutral detergents. • Do not use abrasive products, abrasive cleaning pads or solvents. Internal cleaning • Carefully clean the appliance, including the rubber gasket of the door, with a soft damp cloth. • If you use short duration programmes regularly, these can leave deposits of grease and limescale inside the appliance. To prevent this, we recommend running long duration programmes at least twice a month.
ENGLISH 23 Problem and alarm code The appliance does not fill with water. The display shows . The appliance does not drain the water. The display shows . The anti-flood device is on. The display shows . Possible cause and solution • Make sure that the water tap is open. • Make sure that the pressure of the water supply is not too low. For this information, contact your local water authority. • Make sure that the water tap is not clogged. • Make sure that the filter in the inlet hose is not clogged.
ENGLISH 24 Refer to "Before first use", "Daily use", or "Hints and tips" for other possible causes. Once you have checked the appliance, deactivate and activate the appliance. If the problem occurs again, contact an Authorised Service Centre. For alarm codes not described in the table, contact an Authorised Service Centre. The washing and drying results are not satisfactory Problem Possible cause and solution Poor washing results. • Refer to "Daily use", "Hints and tips" and basket loading leaflet.
ENGLISH 25 Problem Possible cause and solution Unusual foam during washing. • Use the detergent for dishwashers only. • There is a leak in the rinse aid dispenser. Contact an Authorised Service Centre. Traces of rust on cutlery. • There is too much salt in the water used for washing. Refer to "The water softener". • Silver and stainless steel cutlery were placed together. Avoid to put silver and stainless steel items close together.
ENGLISH 26 Technical information Dimensions Width / height / depth (mm) 596 / 818-898 / 550 Electrical connection 1) Voltage (V) 200 - 240 Frequency (Hz) 50 / 60 Water supply pressure Min. / max. bar (MPa) 0.5 (0.05) / 8 (0.8) Water supply Cold water or hot water 2) max 60 °C Capacity Place settings 13 Power consumption Left-on mode (W) 5.0 Power consumption Off-mode (W) 0.10 1) Refer to the rating plate for other values.
ENGLISH the date of purchase from IKEA. This guarantee applies to domestic use only. The exceptions are specified under the headline “What is not covered under this guarantee?” Within the guarantee period, the costs to remedy the fault e.g. repairs, parts, labour and travel will be covered, provided that the appliance is accessible for repair without special expenditure. On these conditions the EU guidelines (Nr. 99/44/EG) and the respective local regulations are applicable.
ENGLISH demands. However these conditions do not limit in any way consumer rights described in the local legislation Area of validity For appliances which are purchased in one EU country and taken to another EU country, the services will be provided in the framework of the guarantee conditions normal in the new country.
Country België Belgique Phone number 070 246016 Call Fee Opening time Binnenlandse gesprekskosten 8 tot 20 Weekdagen Tarif des appels nationaux 8 à 20. En semaine България 00359888164080 0035924274080 Такса за повикване от страната От 9 до 18 ч в работни дни Česká republika 246 019721 Cena za místní hovor Danmark 70 15 09 09 Landstakst 8 až 20 v pracovních dnech man. - fre. 09.00 - 20.00 lør. 09.00 - 16.00 1 søndag pr.
117884451-B-062017 © Inter IKEA Systems B.V.
