GB HYGIENISK
ENGLISH Please refer to the last page of this manual for the full list of IKEA appointed After Sales Service Provider and relative national phone numbers.
ENGLISH 4
ENGLISH Contents Safety information Safety instructions Product description Control panel Programmes Options Settings Before first use 4 6 7 8 9 11 12 15 Daily use Hints and tips Care and cleaning Troubleshooting Technical information Environmental concerns IKEA guarantee 17 18 20 23 26 27 27 Subject to change without notice. Safety information Before the installation and use of the appliance, carefully read the supplied instructions.
ENGLISH • 5 Children shall not carry out cleaning and user maintenance of the appliance without supervision. General Safety • • • • • • • • • • • This appliance is intended to be used in household and similar applications such as: – farm houses; staff kitchen areas in shops, offices and other working environments; – by clients in hotels, motels, bed & breakfast and other residential type environments. Do not change the specification of this appliance.
ENGLISH Safety instructions Installation Warning! Only a qualified person must install this appliance. • Remove all the packaging. • Do not install or use a damaged appliance. • Do not install or use the appliance where the temperature is less than 0 °C. • Follow the installation instructions supplied with the appliance. • Always take care when moving the appliance as it is heavy. Always use safety gloves and enclosed footwear.
ENGLISH 7 • Do not remove the dishes from the appliance until the programme is complete. Some detergent may remain on the dishes. • The appliance can release hot steam if you open the door while a programme operates. • Do not put flammable products or items that are wet with flammable products in, near or on the appliance. • To replace the internal lighting, contact the Authorised Service Centre. Service • To repair the appliance contact an Authorised Service Centre. • Use original spare parts only.
ENGLISH 5 6 7 8 9 8 Rating plate Salt container Air vent Rinse aid dispenser Detergent dispenser TimeBeam TimeBeam displays the following information on the floor below the appliance door: • The programme duration when the programme begins. • 0:00 and CLEAN when the programme is completed. • DELAY and the countdown duration when the delay start begins. • An alarm code when the appliance has a malfunction.
ENGLISH 9 7 DryPlus button 8 RESET button 9 Indicators Indicators Indicator Description End indicator. Rinse aid indicator. It is always off while the programme operates. Salt indicator. It is always off while the programme operates.
ENGLISH 10 Programme P7 5) Degree of soil Type of load • Normal soil • Crockery and cutlery Programme phases • • • • Prewash Wash 50 °C Rinse Dry Options • DryPlus 1) The appliance senses the degree of soil and the quantity of items in the baskets . It automatically adjusts the temperature and the quantity of water, the energy consumption and the programme duration. 2) With this programme you can wash a load with fresh soil. It gives good washing results in a short time.
ENGLISH Information for test institutes To receive the necessary information for conducting performance tests (e.g. according to EN60436), send an email to: For any other questions regarding your dishwasher please refer to the service book provided with your appliance. info.test@dishwasher-production.com In your request please include the product number code (PNC) found on the rating plate. Options Desired options must be activated every time before you start a programme.
ENGLISH 12 Settings Programme selection mode and user mode Press and hold RESET until the appliance is in programme selection mode. When the appliance is in programme selection mode it is possible to set a programme and to enter user mode. How to enter user mode Settings available in the user mode: • The level of water softener according to the water hardness. • Activation or deactivation of the rinse aid empty notification. • The level of rinse aid according to the required dosage.
ENGLISH German degrees French degrees (°dH) (°fH) mmol/l Clarke de- Water softener level grees 19 - 22 33 - 39 3.3 - 3.9 23 - 27 5 1) 15 - 18 26 - 32 2.6 - 3.2 18 - 22 4 11 - 14 19 - 25 1.9 - 2.5 13 - 17 3 4 - 10 7 - 18 0.7 - 1.8 5 - 12 2 <4 <7 <0.7 <5 1 2) 1) Factory setting. 2) Do not use salt at this level. Whether you use a standard detergent or multi-tabs (with or without salt), set the proper water hardness level to keep the salt refill notification active.
ENGLISH quantity) and level 6 (maximum quantity). Level 0 deactivates the rinse aid dispenser and no rinse aid is released. Factory setting: level 4. How to set the rinse aid level Make sure the appliance is in user mode. 1. Press . • The indicators , and , , are off. • The indicator continues to flash. • The display shows the current setting: e.g. = level 4. – The levels of rinse aid range from 0A to 6A where level 0A means rinse aid is not used. 2. Press repeatedly to change the setting. 3.
ENGLISH 15 If children, pets or people with disabilities have access to the appliance, deactivate AutoOpen. The automatic opening of the door may pose a danger and expose possible hazards inside the appliance (such as knives, sharp objects, chemicals). How to deactivate AutoOpen Make sure the appliance is in user mode. AutoOpen is automatically activated with all programmes excluding applicable). (if To improve the drying performance refer to the DryPlus option or activate AutoOpen.
ENGLISH 16 Filling the salt container Filling the rinse aid dispenser 1 2 1 2 3 4 3 4 A Put 1 litre of water in the salt container (only for the first time). 5 Put 1 kg of salt in the salt container. Turn the cap of the salt container clockwise to close the salt container. Caution! Water and salt may come out of the salt container when you fill it. After you fill the salt container, immediately start a programme to prevent corrosion.
ENGLISH Daily use 1. Open the water tap. 2. Press the on/off button to activate the appliance. Make sure that the appliance is in programme selection mode. • If the salt indicator is on, fill the salt container. • If the rinse aid indicator is on, fill the rinse aid dispenser. 3. Load the baskets. 4. Add the detergent. 5. Set and start the correct programme for the type of load and the degree of soil.
ENGLISH 18 programme you want to start. The display will show the programme number for approximately 3 seconds and next the programme duration. 4. Set the applicable options. 5. Close the appliance door to start the programme. Cancelling the delay start while the countdown operates Starting a programme with delay start Cancelling the programme 1. Set a programme. 2. Press repeatedly until the display shows the delay time you want to set (from 1 to 24 hours). The delay indicator comes on. 3.
ENGLISH • • • • available) or select a programme with a prewash phase. Always use the whole space of the baskets. When loading the appliance, make sure that the dishes can be completely reached and washed by the water released from the spray arm nozzles. Make sure that items do not touch or cover each other. You can use dishwasher detergent, rinse aid and salt separately or you can use the multi-tablets (e.g. ''3in1'', ''4in1'', ''All in 1''). Follow the instructions written on the packaging.
ENGLISH Before starting a programme Make sure that: • The filters are clean and correctly installed. • The cap of the salt container is tight. • The spray arms are not clogged. • There is dishwasher salt and rinse aid (unless you use multi- tablets). • The position of the items in the baskets is correct. • The programme is applicable for the type of load and for the degree of soil. • The correct quantity of detergent is used. 20 1. Let the dishes cool down before you remove them from the appliance.
ENGLISH 3 4 Cleaning the filter of the inlet hose 1 2 A To remove filters (B) and (C) turn the handle counterclockwise and remove. Pull apart filter (B) and (C). Wash the filters with water. 5 Remove filter (A). Wash the filter with water. Close the water tap. Disconnect the hose. Turn the fastener A clockwise. 3 4 6 D Clean the filter of the inlet hose. Put the flat filter (A) Assemble filters (B) back in place. Make and (C).
ENGLISH 22 External cleaning • Clean the appliance with a moist soft cloth. • Only use neutral detergents. • Do not use abrasive products, abrasive cleaning pads or solvents. Internal cleaning 3. Wash the spray arm under running water. Use a thin pointed tool, e.g. toothpick, to remove particles of soil from the holes. 4.
ENGLISH 23 Troubleshooting If the appliance does not start or it stops during operation, first check if you can solve the problem by yourself with the help of the information in the table or contact an Authorised Service Centre. With some problems, the display shows an alarm code. The majority of problems that can occur can be solved without the need to contact an Authorised Service Centre. Warning! Repairs not properly done may result in serious risk to the safety of the user.
ENGLISH 24 Problem and alarm code Possible cause and solution The program lasts too long. • If the delayed start option is set, cancel the delay setting or wait for the end of the countdown. The remaining time in the display increases and skips nearly to the end of program time. • This is not a defect. The appliance is working correctly. Small leak from the appliance door. • The appliance is not levelled. Loosen or tighten the adjustable feet (if applicable).
ENGLISH Problem 25 Possible cause and solution Poor drying results. • Tableware has been left for too long inside a closed appliance. • There is no rinse aid or the dosage of rinse aid is not enough. Set the rinse aid dispenser to a higher level. • Plastic items may need to be towel dried. • For the best drying performance activate the option DryPlus and set AutoOpen. • We recommend to always use rinse aid, even in combination with multi-tablets.
ENGLISH 26 Problem Possible cause and solution There are residues of detergent in the dispenser at the end of the programme. • The detergent tablet got stuck in the dispenser and therefore was not completely washed away by water. • Water cannot wash away the detergent from the dispenser. Make sure that the spray arm is not blocked or clogged. • Make sure that items in the baskets do not impede the lid of the detergent dispenser from opening. Odours inside the appliance.
ENGLISH 27 Capacity Place settings 15 Power consumption Left-on mode (W) 5.0 Power consumption Off-mode (W) 0.10 1) Refer to the rating plate for other values. 2) If the hot water comes from alternative source of energy, (e.g. solar panels, aeolian energy), use the hot water supply to decrease energy consumption. Environmental concerns Recycle materials with the symbol . Put the packaging in relevant containers to recycle it.
ENGLISH • Deliberate or negligent damage, damage caused by failure to observe operating instructions, incorrect installation or by connection to the wrong voltage, damage caused by chemical or electro-chemical reaction, rust, corrosion or water damage including but not limited to damage caused by excessive lime in the water supply, damage caused by abnormal environmental conditions. • Consumable parts including batteries and lamps.
ENGLISH kitchen furniture. The service won’t provide clarifications related to: • the overall IKEA kitchen installation; • connections to electricity (if machine comes without plug and cable), to water and to gas since they have to be executed by an authorized service engineer. 3. ask for clarification on user manual contents and specifications of the IKEA appliance.
Country Phone number België Belgique 070 246016 Call Fee Opening time Binnenlandse gesprekskosten 8 tot 20 Weekdagen Tarif des appels nationaux 8 à 20. En semaine България 00359888164080 0035924274080 Такса за повикване от страната От 9 до 18 ч в работни дни Česká republika 246 019721 Cena za místní hovor 8 až 20 v pracovních dnech Danmark 70 15 09 09 Landstakst man. - fre. 09.00 - 20.00 lør. - søn. 09.00 - 18.
117889331-A-052018 © Inter IKEA Systems B.V.
