PILKÅN
English Installation must be performed in compliance with current local construction and plumbing regulations. If in doubt, contact a professional. English Switch off main shut-off valve before changing mixer tap.
5 4 3 2 25 1 6 7 100 8 125 0 0 Max. 60˚C Max. 80˚C 50 75 9 145 bar psi 10 0,2 - 5 bar 0,1 - 10 bar G1/2 5 4 6 7 3 8 2 9 1 0 10 0,5 - 5 bar 0,2 - 10 bar 120172 Max. 60˚C Max.
2 120143 1 126908 120172 120141 50 mm max. 2" max.
3 English IMPORTANT! Do not tighten too hard: this can damage hoses/pipes and washers.
10004080 Pre-fitted Low pressure 124607 High pressure 124607 Pre-fitted High pressure 139268 Low pressure English Before use: Unscrew the Aerator/Flow Guide with a coin and allow the water to run freely for a few minutes. Then screw the Aerator/Flow Guide back in place up to the stop DO NOT OVER TIGHTEN. English Check at regular intervals to make sure that the installation is not leaking.
11008 4 English Inlet supply hoses shall be installed where light is excluded. English Water supplies shall be at reasonably balanced pressures from a common source (e.g. hot and cold supplies both from the same storage or both from a supply pipe). Where the fitting is supplied from unbalanced supplies (e.g.
124607 Pre-fitted High pressure 139268 Low pressure 124607 High pressure 8 120172 126908 120143 120141 120142 10004080 Pre-fitted Low pressure G1/2 © Inter IKEA Systems B.V.
