User Manual

124607
Pre-tted
High pressure
139268
Low pressure
8 AA-2246293-1
Before use: Unscrew the Aerator/Flow Guide with
a coin and allow the water to run freely for a few
minutes. Then screw the Aerator/Flow Guide back
in place up to the stop DO NOT OVER TIGHTEN.
Check at regular intervals to make sure that the
installation is not leaking.
Inlet supply hoses shall be installed where light is
excluded.
Water supplies shall be at reasonably balanced
pressures from a common source (e.g. hot and
cold supplies both from the same storage or
both from a supply pipe). Where the tting is
supplied from unbalanced supplies (e.g. hot
and cold supplies from separate sources) an
‘Approved’ single check valve or some other no
less eective backow prevention device shall be
tted immediately upstream of both hot and cold
water inlets.