BROGRUND
Installation must be performed in compliance with current local construction and plumbing regulations. If in doubt, contact a professional. 2 Switch off main shut-off valve before changing mixer tap.
2x 1x 1x 2x 110084 121844 121846 121845 121842 2x 1x 3
5 6 7 3 8 2 9 1 0 bar psi 0,5 - 5 bar 0,2 - 10 bar 110084 60˚C Max.
121842 1 5
2 Ø 34 - 37 mm Ø 1 3/8 - 1 1/2" 121844 121845 121846 50 mm max. 2" max.
3 IMPORTANT! Do not tighten too hard: this can damage hoses/pipes and washers.
Before use: Unscrew the Aerator/Flow Guide with a coin and allow the water to run freely for a few minutes. Then screw the Aerator/Flow Guide back in place up to the stop DO NOT OVER TIGHTEN. 124607 Pre-fitted High pressure Check at regular intervals to make sure that the installation is not leaking. 139268 Low pressure Inlet supply hoses shall be installed where light is excluded. Water supplies shall be at reasonably balanced pressures from a common source (e.g.
