User Manual

When the cleaning is completed, do the
above steps in the opposite sequence. Install
the smaller panel rst, then the larger and
the door.
One of the hinge-arms (normally
the right one) is free to move.
Make sure, that both hinge-arms
are in the same position
(approximately 70° angle).
Warning! Make sure that the
glasses are inserted in the correct
position otherwise the surface of
the door may overheat.
Replacing the lamp
Put a cloth on the bottom of the interior of
the oven. It prevents damage to the lamp
glass cover and the cavity.
Warning! Danger of
electrocution! Disconnect the fuse
before you replace the lamp.
The lamp and the lamp glass
cover can be hot.
1. Turn o the oven.
2. Remove the fuses from the fuse box or
turn o the circuit breaker.
3. Turn the lamp glass cover
counterclockwise to remove it.
4. Clean the glass cover.
5. Replace the oven light bulb with a 40 W,
230 V (50 Hz), 350 °C heat resistant oven
light bulb (connection type: G9).
6. Install the glass cover.
Troubleshooting
Warning! Refer to Safety
chapters.
What to do if...
Problem Possible cause Remedy
The oven does not heat up. The oven is turned o. Turn on the oven.
The oven does not heat up. The clock is not set. Set the clock.
The oven does not heat up. The necessary settings are
not set.
Make sure that the settings
are correct.
The oven does not heat up. The automatic switch-o is
on.
Refer to "Automatic switch-
o".
The oven does not heat up. The Child Lock is on. Refer to "Using the Child
Lock".
The oven does not heat up. The door is not closed cor‐
rectly.
Fully close the door.
ENGLISH 25