Instruction Manual

u IBX-210-CV-N2600 Embedded System
Page 30
Figure 3-25: RS-422/485 Cable
Step 3: Insert the serial connector. Insert the DB-9 connector of a serial device into
the DB-9 connector on the RS-422/485 cable.
Step 4: Secure the connector. Secure the serial device connector to the external
interface by tightening the two retention screws on either side of the connector.
3.8.6 USB Device Connection
There are four USB 2.0 connectors on the uIBX-210-CV-N2600. To connect a USB device,
please follow the instructions below.
Step 1: Locate the USB connectors. The locations of the USB connectors are shown
in Chapter 1.
Step 2: Align the connectors. Align the USB device connector with one of the
connectors on the uIBX-210-CV-N2600. See Figure 3-26.
Figure 3-26: USB Device Connection