Manualshelf

How to Guide

ManualsBrandsIDEAL ManualsHand Tools7-Piece Steel Handle Phillips Multi-Bit Screwdriver Set
12
Adjustable Torque Screwdriver
Operating Instructions
The IDEAL INDUSTRIES, INC. adjustable torque screwdrivers are designed and manufactured to provide consistent user-settable torque in varying
assembly or maintenance applications. These tools meet or exceed ASME B107.300-2010 and ISO 6789 specifications of +/- 6% preset value accuracy
from 20% to 100% of capacity, and +/- 1.2% of capacity below 20% of capacity. These tools meet or exceed this requirement in both the clockwise and
counter-clockwise directions.
Our adjustable torque screwdrivers signal the operator that the torque setting has been attained by emitting a distinct audible and tactile impulse (click”).
These adjustable torque screwdrivers do have graduations and the torque must be set to the desired level before use.
35-936
Shaft
(Bit Holder on end.)
Handle
Adjustable Torque Key
Lens &
Lens Line
Cautions
• Always wear appropriate safety equipment when using any hand tool.
• Only use hand tools for their intended purpose.
• Never exceed the rated capacity of the tool.
Capacity, Range and Graduation
35-936 ...........2-36 inch-pounds/2-4 Nm ..................2 in. lbs./.2 Nm
Setting the Torque
1. Remove the black vinyl cap from the rear of the screwdriver.
2. Raise the Torque Adjusting Key from the stored and locked position. Remove set screw
3. Rotate the torque adjusting key to align the lens line with the desired torque.
a. Use the markings on the shaft to determine torque scale and setting.
b. Rotate the Torque Adjusting Key clockwise (CW) to increase the torque setting.
c. Rotate the Torque Adjusting Key counter-clockwise (CCW) to decrease the torque setting.
4. When the desired torque is directly under the Lens Line, fold the Torque Adjusting Key back to thestored and locked position. If desired, use the
enclosed screw to affix the Torque Adusting Key inplace.
5. Replace the black vinyl cap on the rear of the screwdriver.
Operating The Screwdriver
1. Set torque per procedure above.
2. Insert the bit (or adapter and socket) into bit holder on end of shaft.
3. Engage fastener completely with bit (or socket).4.Rotate screwdriver steadily until “click” is heard and felt. Further rotation will not tighten fastener
further.
Use of Extensions and Adapters
Only in-line extensions, bits and adapters should be used with your screwdriver. The maximum recommended overall length of any extension is
six inches (6”).
Care and Cleaning
Return screwdriver to its lowest setting when it is to be stored for any period of time. Clean the screwdriver with a soft, damp cloth. Do not immerse the
screwdriver in cleaning fluids.

Summary of content (2 pages)