How to Guide

30-496 IDEAL TeleMaster™ Instructions

1) Use the cutting blade to remove old

connector if necessary. Start with a

clean, straight cut on the end of the

cable.

2) Use the round stripping hole to remove 2”

of jacket. Rotate the tool around the cable

to score the outer cable jacket. Bend cable

gently at the score mark to remove the 2”

jacket slug. Avoid cuttting too deep into the

cable or the twisted pairs may get nicked.

3) Arrange wires into proper order for your

application requirements

4) Trim wires to 1/2” of exposed length

using the cutter

5) Insert wires into modular plug and crimp in the appropriate

cavity of the tool. Squeeze handles closed and remove cable

assembly.

Optional (but highly recommended): test your cable assembly

with an IDEAL wiremap tester. VDV or LinkMaster™

30-496 TeleMaster

Finished cable assembly:

A)Conductors inserted to end of connector

B)Cable jacket past primary crimp area

CUTTER

STRIPPER

RJ-45 CRIMPER

RJ-11 CRIMPER

2 inches

1/2 inch

Pair 2

Pair 4

Pair 3Pair 1

Pair 2

Pair 4

Pair 3

Pair 1

568A

568B

Insert into connector with tab side down

IDEAL INDUSTRIES, INC

Becker Place, Sycamore, IL 60178 USA

815-895-5181 • 800-435-0705 in USA

www.idealindustries.com 7/12

Tab