Operation Manual

SPECIFICATIONS AND OPTIONS

New2001

■ Using the HM-222

NOTE:

• NEVER immerse the connector in water. If the connector

becomes wet, BE SURE to dry it before attaching to the

transceiver.

• The microphone element is located at the top left of the

speaker microphone, as shown in the illustration above.

To maximize the readability of your transmitted audio,

hold the microphone approximately 5 to 10 cm (2 to 4

inches) from your mouth, and then speak at your normal

voice level.

Turn OFF the

transceiver

before attaching

or detaching the

microphone

[PTT]

[H/L]

Speaker

Microphone

Earphone jack

Belt clip

You can connect

an earphone (user

supplied) to the

earphone jack on

the microphone.

To attach:

Attach the connector of the speaker microphone to

the multi connector on the transceiver and tighten the

screw.

Screw

Coin

CAUTION: Firmly attach to the multi

connector, but do not overtighten.

A loose connection will allow water

intrusion into the connector. Over-

tightening the connection can

damage the transceiver.

Turn OFF