Operation Manual

43
15
OPTIONS
New2001
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
D BATTERY CASE AND PACK
• BP-245N Li-ion b at t e r y p a c k
The same as supplied with the transceiver.
Voltage : 7.4 V
Capacity : 1900 mAh (minimum)/2000 mAh (typical)
D CHARGERS
• BC-210 d e s k t o p c h a r g e r + BC-123SA/SE/SV a c a d a p t e r
For rapid charging of battery packs. The same as supplied with the
transceiver. An AC adapter is supplied with the charger depending
on versions.
Charging time: Approximately 2.5 hours
• BC-197 m u l t i -c h a r g e r + AD-129 c h a r g e r a d a p t e r (6 pcs.)
+ BC-157S a c a d a p t e r
For rapid charging of up to 6 battery packs (six AD-129’s are
required) simultaneously. An AC adapter should be purchased
separately.
Charging time: Approximately 2.5 hours.
DC CABLES D
• CP-25H c i g a r e t t e l i g h t e r c a b l e
The same as supplied with some of the transceiver versions.
Specification: 12 V DC/1 A
NOTE: The CP-25H is
equipped with a 2 A
fuse. If the fuse blows,
replace it with a new
rated fuse. DO NOT
use a fuse with amp
ratings other than this
rating.
• OPC-515L/OPC-656
d c p o w e r c a b l e s
Charges the battery pack using 13.8 V power source instead of the
AC adapter.
OPC-515L: For BC-210
OPC-656 : For BC-197
D BELT CLIPS
• MB-103 b e lt c l i p
The same as supplied with the transceiver.
• MB-86 s w i v e l b e l t c l i p
Belt clip for swivel type.
• MB-96N/F l e at h e r b e lt h a n g e r
D OTHER OPTIONS
• HM-167 s p e a k e r -m i c r o p h o n e
Full sized waterproof speaker-microphone including alligator type
clip to attach to your shirt or collar, etc.
• HM-202 s p e a k e r -m i c r o p h o n e
The HM-202 meets IP67 requirements for waterproof protection.
Once the item has been dropped, the waterproof protection cannot be
guaranteed because of possible damage to the case or the waterproof
seals.
• FA-S59V*/FA-S64V f l e x i b l e a n t e n n a
*For only for the EUR, UK, FRG and HOL versions.
Approved Icom optional equipment is designed for optimal perfor-
mance when used with an Icom transceiver. Icom is not responsible
for the destruction or damage to an Icom transceiver in the event the
Icom transceiver is used with equipment that is not manufactured or
approved by Icom.
Available or applicable options may differ according to
countries. Ask your authorized dealer for details.
CP-25H : (2 A / 250 V)
Fuse