Operation Manual
2
PANEL DESCRIPTION
2-18
Assignable Software key functions
Category: Signaling/Call (Continued)
Status
Push to display the “Status List” screen. Then, push
[Up] or [Down] to select a Status message.
After selecting, push [PTT] to send the message to
the currently selected station or group. Or, push [OK]
to set.
L See pages 7-6, 8-14 for details.
Message
While in the Standby mode, push to display the
“Message List” screen. Then, push [Up] or [Down] to
select a message.
After selecting, push [PTT] to send the message to
the currently selected station or group.
L See pages 7-8, 8-16 for details.
Write Message
In the Digital mode
Push to display the “Write Message” screen.
After entering, push [PTT] to send the message to the
currently selected station or group.
L See page 7-9 for details.
Category: Trunking
Site Select
In the Digital mode
z Push to display the “Site Select” screen. Then, push
[Up] or [Down] to select a site number.
After selecting, push [OK] to set the selected site.
• The selected site is locked.
z While in the Standby mode, hold down [Site Select]
for 1 second to unlock the site.
Site Lock
In the Digital mode
Push to turn the Site Lock function ON or OFF.
L When this function is turned ON, the transceiver cancels
resuming a roaming scan, and stays on the current site,
regardless of the error rate.
Roaming Request
In the Digital mode
Push to turn the Roaming Request function ON or
OFF.
L When this function is turned ON, the transceiver starts or
resumes a roaming scan, regardless of the error rate.
L When the Site Lock function is turned ON, pushing this
key resumes a roaming scan.
Category: Functions
Light
Push to turn ON the backlight for about 5 seconds,
even if the backlight setting is OFF.
Lock
Hold down for 1 second to turn the Key Lock function
ON or OFF.
L All assignable keys except the following are electronically
locked: [Monitor], [Light], [Lock], [Call], [Emergency], and
[Surveillance]. Also, [PTT] and [Power] are usable.
Public Address (For the Mobile type transceivers)
Push to activate the Public Address (PA) function.
And then, speak into the microphone while holding
down [PTT].
L When the PA function is activated, the audio output can
be separately controlled from the transceiver by pushing
[Up] or [Down].
NOTE: This function is usable when an external
unit, such as a audio amplier, speaker, and so on is
connected to the D-sub 25-pin connector.
RX Speaker (For the Mobile type transceivers)
Push to turn the RX Speaker function ON or OFF.
L When the RX Speaker function is turned ON, the received
audio can be heard through an external speaker that is
connected to the D-sub 25-pin connector.
NOTE:
• This function is usable when an external speaker
that is connected to the D-sub 25-pin connector.
• This function is useful when a user is out of the
vehicle.
• The audio output level is linked to the transceiver’s
volume control.
Hook Scan (For the Mobile type transceivers)
Push to temporarily turn the Hook Scan function ON
or OFF.
Horn (For the Mobile type transceivers)
Push to turn the Horn function ON or OFF.
L When the Horn function is ON, the HORN terminal of the
D-Sub 25 pin or Option Connector 22 pin is activated after
receiving a call*.
* Only a call that the Dec EXO or RX EXO setting is ON.
L This function is useful when a user is away from the
transceiver.
NOTE: This function is usable when an external horn
is required.
D For keys and keypads
Previous view