Operation Manual

11
Bluetooth
®
OPERATION
11-4
Turning ON the Bluetooth
®
function (Continued)
NOTE: For the Portable Ten-key and the Simple
key types and Mobile LCD types
• To turn ON the Bluetooth
®
function: See page 11-3
• To pair with a headset: See page 11-6
• To pair with a data device: See page 11-9
Portable:
Step 1: Entering the Bluetooth
®
Set mode
(Transceiver)
1. Turn OFF the transceiver.
2. Set [Selector] to any channel other than Channel
16.
3. While holding down [F1], turn ON the transceiver.
Continue holding down [F1] for about 3 seconds.
• 2 beeps sound.
• The transceiver enters the Bluetooth
®
Set mode.
Step 2: Entering the Pairing mode
(Bluetooth
®
device)
L See the Bluetooth
®
device’s instruction manual for
details.
Step 3: Turning ON the Bluetooth
®
function
(Transceiver)
After the headset has entered the Pairing mode, push
[F2] to turn ON the Bluetooth
®
function.
• The transceiver automatically enters the Pairing mode, and
begins searching for a Bluetooth
®
headset.
• While searching, the status indicator quickly blinks blue.
L If the status indicator does not blink after pushing [F2], the
transceiver has not entered the Bluetooth
®
Set mode. In
that case, do step 1 again.
Step 4: Pairing with a headset (Transceiver)
When a headset is found, the transceiver pairs with it.
• After the transceiver and the headset pairing has
succeeded, the Status indicator slowly blinks blue 3 times.
In that case, the connection to the headset has also
succeeded.
LThetransceiversearchesforaheadsetrst.After
searching for a headset, the transceiver will start
searching for a data device. To skip searching for a data
device, push [PTT] on the headset.
L If the Bluetooth
®
connection fails, the Status indicator
slowly blinks red 3 times. To search for a headset again,
push [F3] to turn OFF the Bluetooth
®
function, then push
[F2] to turn it ON again.
This section describes how to turn ON the Bluetooth
®
function and start pairing using the Portable Non-
display types or Mobile Segment types.
[VOL]
[F1]
[F2]
[F3]
Step 5: Pairing with a data device (Transceiver)
1. When a data device is found, the transceiver pairs
with it.
• After the transceiver and the data device pairing has
succeeded, the Status indicator slowly blinks blue 3
times. In that case, connection to the data device has
also succeeded.
L If the Bluetooth
®
connection fails, the Status indicator
slowly blinks red 3 times. To search for a data device
again, push [F3] to turn OFF the Bluetooth
®
function,
then push [F2] to turn it ON again. The transceiver
automatically tries to connect.
2. Turn OFF the transceiver, then turn it ON again to
exit the Bluetooth
®
Set mode.
D For the Portable Non-display types and Mobile Segment types
TIP: To turn OFF the Bluetooth
®
function, push [F3]
in the Bluetooth
®
Set mode.
Previous view