Operation Manual

BIIS OPERATION

Direct code entry

q While in the standby condition, push [TX Code Enter] to enter

the TX code edit mode.

• Editable code digit blinks.

w Push [TX Code Enter] to select the desired digit to be edited.

• Editable digit differs according to the setting.

e Set the desired digit using [ ]/[ ]/[TX Code CH Up]/[TX

Code CH Down].

r Push [TX Code Enter] to set the digit. The editable digit will move

to the right automatically.

t Repeat e and r to input all allowable digits.

y Push [P0] (Call) or [PTT]* to call.

*PTT call can be made only when PTT call capability is permitted.

NOTE: When no answer back is received, the transceiver re-

peats the call 3 times (default) automatically, and

“”is

displayed during each call. However, an error beep sounds

and

“”is displayed when no answer back is received

after the calls.

u Push [PTT] to transmit; release to receive.

i Push [P3] (Moni(Audi)) to send the “Clear down” signal.

For your information

When the “UpDate” setting for the call code is enabled, the set code

is overwritten into the call code memory.

IC-F50_F60 BIIS-6.qxd 06.7.14 0:58 PM Page 25 (1,1)