Operation Manual

24
4
BIIS OPERATION
4
DD
Calling back from the queue channel
q While in the standby condition, push [P1] (Digital) for 1 sec. to
enter queue memory channel selection mode.
w Push [ ]/[ ] to select the desired record.
e Push [P0] (Call) or [PTT]* to call.
*PTT call can be made only when PTT call capability is permitted.
NOTE: When no answer back is received, the transceiver re-
peats the call 3 times (default) automatically, and
“”is
displayed during each call. However, an error beep sounds
and
“”is displayed when no answer back is received
after the calls.
r Push [PTT] to transmit; release to receive.
t Push [P3] (Moni(Audi)) to send the “Clear down” signal.
IC-F50_F60 BIIS-6.qxd 06.7.14 0:58 PM Page 24 (1,1)