Operation Manual

CE Versions of the IC-F310/S which display the

“CE” symbol on the serial number seal, comply with

the essential requirements of the European Radio

and Telecommunication Terminal Directive

1999/5/EC.

This warning symbol indicates that this equipment

operates in non-harmonised frequency bands

and/or may be subject to licensing conditions in the

country of use. Be sure to check that you have the

correct version of this radio or the correct program-

ming of this radio, to comply with national licensing

requirement.

■■ GER ■■ NED ■■ ITA

■■ AUT ■■ BEL ■■ GRE

■■ GBR ■■ LUX ■■ SWE

■■ IRL ■■ ESP ■■ DEN

■■ FRA ■■ POR ■■ FIN

55-#54,58,59/ 66-#54,59 A -5458D-4EU

INSTALLATION NOTES

The installation of this equipment should be made in such a manner

as to respect the EC recommended electromagnetic field exposure

limits (1999/519/EC).

The maximum RF power available from this device is 25 watts. The

antenna should be installed as high as possible for maximum effi-

ciency and that this installation height should be at least 5 meters

above ground (or accessible) level. In the case where an antenna

cannot be installed at a reasonable height, then the transmitter should

neither be continuously operated for long periods if any person is

within 5 meters of the antenna, nor operated at all if any person is

touching the antenna.

In all cases any possible risk depends on the transmitter being acti-

vated for long periods. (actual recommendation limits are specified

as an average of 6 minutes) Normally the transmitter is not active for

long periods of time. Some radio licenses will require that a timer cir-

cuit automatically cuts the transmitter after 1–2 minutes etc.

Similarly some types of transmitter, SSB, CW, AM, etc. have a lower

‘average’ output power and the perceived risk is even lower.

ABOUT CE