Owner's manual

31
Chapter 3: Operation
5. <SCAN EDIT>
 <SCAN EDIT>
User can program dome when running <SCAN MODE>, each dome 3 different scan modes.
To program, go to <SCAN EDIT> page,
<SCAN MODE>
360 : Dome will keep rotating 360∘
A←B : Dome will keep repeating from position B to position A
A→B : Dome will keep repeating from position A to position B
<POSITION A>
User can set which preset as position A
<POSITION B>
User can set which preset a position B
SCAN EDIT
SCAN MODE： 360/A←B/A→B
POSITION A：
PRE001～128/NO
USE
POSITION B：
PRE001～128/NO
USE
BACK
EXIT
CAMERA SETUP
CAMERA SETUP
MOTION SETUP
TITLE EDIT
TOUR EDIT
SCAN EDIT
PATTERN EDIT
MASK EDIT
POWER ON：SCAN
BACK
EXIT