User's Manual


6WDUWLQJ9RLFH5HFRJQLWLRQ
Starting Voice Recognition
Shortly press the
key on the steering
remote controller (under 0.8 seconds) ƙ
Say a command
Once voice recognition starts, the voice com-
mand entry window and the six representative
commands are displayed.
У
If voice recognition is in [Normal Mode],
then the system will say "Please say a com-
mand."
"
Beep~
"
У
If voice recognition is in [Expert Mode], then
the system will only say a
"
Beep~
"
(e.g. : screen displayed when ‘Help’ is stated)
NOTICE
У
For proper recognition, say the command
after the voice instruction and beep tone.
i
Information
У
To change the Normal/Expert setting,
press the
6HWXS
key and enter the
Voice Recognition settings screen.
Skipping Prompt Messages
While prompt message is being stated
ƙ Shortly press the
key on the
steering remote controller (under 0.8
seconds)
The prompt message is immediately ended
and the beep tone will sound. After the
"
beep
"
, say the voice command.
8VLQJ9RLFH5HFRJQLWLRQ
6WDUWLQJ9RLFH5HFRJQLWLRQ
9RLFH5HFRJQLWLRQ
l

Re-starting Voice Recognition
While system waits for a command Shortly
ƙpress the
key on the steering remote
controller (under 0.8 seconds)
The command wait state is immediately
ended and the beep ton will sound. After the
"beep", say the voice command.
(QGLQJ9RLFH5HFRJQLWLRQ
While Voice Recognition is operating
ƙ Press and hold the
key on the
steering remote controller (over 0.8
seconds)
While using voice command, pressing a
steering wheel remote control or a different
key will end voice command.
i
Information
У
In a state where the system is waiting
for a voice command, say "cancel" or
"exit" to end voice command.
У
In a state where the system is waiting
for a voice command, press and hold
the
key on the steering remote con-
troller to end voice command.