Lawn Mower User Manual

EQUIPMENT SETUP AND ADJUSTMENTS

1. Uncrate mower

2. Mount drive wheels using the four lug nuts installed on the hub.

3. Check tire pressure in all four tires. Pressure for all four tires is 15 psi

4. Remove the motion control levers and install on the outside of the control arms (See figure

1). Tabs on the motion control levers should be directed to the rear of the mower. Align the

levers so they are even in the neutral position. (See figure 6)

5. Install seat rod to the seat frame with 5/16" hardware. Seat rod is located under the seat in

the hydraulic pump area. Attach the rod to the tab on the seat frame.

6. Check engine oil with dip stick. Add if needed per engine manufactures specifications.

(See Kohler engine manual engine specifications.)

Normally filled with Quaker State 10W30 and ran in at the factory.

7. See enclosed literature for proper installation, care and charging of battery.

8. Loosen the discharge chute slightly and lower into position. Chute should be snug but still

pivot freely.

Figure 1