Operators Manual

English-17
CONTROLS
Cutting height
The cutting deck height is obtained by raising
the wheels for low cut and lower wheels for
high cut, adjust cutting height to suit your
requirements. Medium position is best for
most lawns.
To change your cutting height, squeeze
adjuster lever toward wheel. Move wheel up
or down to suit your requirements. Be sure all
wheels are in the same setting.
NOTE: Adjuster is properly positioned when
plate tab inserts into hole in lever. Also, 9-
position adjusters (if so equipped) allow lever
to be positioned between the plate tabs.
Ground Drive Bail
The ground drive bail for models so equipped,
is used to engage the drive wheels.
The ground drive bail is engaged by pressing
the bail forward to engage the drive wheels.
Release the ground drive bail to stop rear
wheels from driving.
1
Ground drive bail, Models: W21SBK, W53SBEK
1
1
2
3
1. Lever backward to lower mower
Lever forward to raise mower
2. Lever
3. Plate Tab
Ground drive bail, Models: W21SK, W53SEK
No ground drive bail, Model: W21K
8019-038
8019-039
8019-046
8019-029
8019-045