Operators Manual

English-21
OPERATION
TO START ENGINE
NOTE: Due to protective coatings on the
engine, a small amount of smoke may be
present during the initial use of the product
and should be considered normal.
To start a cold engine, push the throttle
control lever to the choke position.
Models: W21SBK & W53SBEK
Pull starter cord briskly. It is not necessary to
engage OPC control. Do not engage ground
speed control bail. When engine starts, move
the throttle control to fast position. Do not
allow the starter cord to snap back.
Models: W21SK, W53SEK
Hold Operator Presence Control in engaged
position. Do not engage the Ground Speed
Control Bail. Pull the starter cord briskly.
When the engine starts, move the throttle
control to fast position. Do not allow the
starter cord to snap back.
Model: W21K
Hold Operator Presence Control in engaged
position. Pull the starter cord briskly. When
the engine starts move the throttle control to
fast position. Do not allow the starter cord to
snap back.
NOTE: In cooler weather it may be necessary
to choke engine. In warmer weather, it may
not be necessary to choke the engine. Too
much choke may cause engine flooding and
prevent the engine from starting. If the engine
becomes flooded, wait a few minutes before
attempting to start.
1. Starter cord
2. OPC
3. Ground speed bail
1. OPC engaged position
2. Ground speed bail
3. Starter cord
1. OPC engaged position
2. Starter cord
8019-015
Pull start, Models: W21SK, W53SEK
8019-016
Pull start, Model:W21K
1
2
3
8019-014
Pull start, Models: W21SBK, W53SBEK
1
3
2
1
2