Owner's Manual

OPERATION

Moving Machine By Hand

When pushing or pulling the mower, engage the

EZT bypass linkages. The EZT bypass linkages are

located on the rear of the frame, below the rear engine

guard.

1. Raise the deck into the highest cutting position.

2. Engage the parking brake.

3. Pull the EZT bypass linkages up and out of the

keyhole slots. Release the levers with the head

outside the frame and held in the bypass position.

4. To reengage the EZT’s to drive, reverse the above

procedure.

Load the machine into truck or trailer by driving slowly

up the ramps. DO NOT LIFT! The machine is not

intended to be lifted by hand.

WARNING!

Make no adjustments without:

• the engine stopped,

• the ignition key removed,

• the parking brake activated

WARNING!

Use extreme caution when loading the

machine into a truck or trailer using

ramps. There is the possibility of

serious injury or death if the machine

falls off the ramps.

WARNING!

Bypass linkages are located close

to the mufﬂer. To prevent burns, the

engine should be shut off and allowed

to cool before the bypass linkage

levers are handled.

8058-150

Bypass linkages

8058-033

1. EZT engaged

2. EZT locked in the bypass

Bypass linkage - left hand side