Lawn Mower User Manual
OPERATION
32
Moving Machine By Hand
When pushing or pulling the mower, be sure to
engage the EZT Hydrogear bypass linkages. The EZT
bypass linkages are located on the rear of the frame,
below the rear engine guard.
1. Raise the deck into the highest cutting position.
2. Pull the EZT bypass linkages out and into the
slots. Release linkages to hold in the bypass
position.
3. Release park brake.
4. To reengage the EZT’s to drive, reverse the above
procedure.
8050-018
Set bypass linkages into slots on both sides
WARNING!
Make no adjustments without:
• the engine stopped,
• the ignition key removed,
• the parking brake activated
WARNING!
Bypass linkages are located close
to the muffler. To prevent burns, the
engine should be shut off and allowed
to cool before the bypass linkage
levers are handled.