Operation Manual

Instruction book Rose
10
Threading the upper thread
!
Switch off the
main switch.
Make sure the presser
foot is raised and the
needle is in the up
position
1. Pull the spool pin out.
Place the thread on
the spool pin and the
spool holder on the spool pin as
described. Push the spool pin
back in.
2. Bring the thread in the direction
of the arrow under the thread
guide (a) and over the thread
guide (b).
3. Bring the thread down between
the thread tension discs.
4. Continue threading by drawing
the thread from the right into the
slot on the take-up lever.
5. Thread last guide just above
needle.
6. The needle is threaded from front
to back. The white on the presser
foot ankle makes it easy to see
the eye of the needle.
Upper thread warning
If the upper thread breaks or if
thread spool runs out, the machine
stops and gives a signal. The symbol
is flashing on the display.
If thread breaks: Re-thread the
machine. The symbol goes out.
If thread spool runs out: Remove
your work and the bobbin. Re-
thread the machine. Replace the
bobbin and restart.
7. Place thread under the presser
foot and into the thread knife
where it is cut.
Procedures