Operators Manual

English – 23
MAINTENANCE
Adjusting the throttle wire
If the engine does not respond as it should do when
the throttle lever is moved or if the top speed is not
reached, the throttle wire may need adjusting.
1. Loosen the clamping screw (by the arrow), and
slide the throttle to the choke position.
2. Pull the throttle wire’s casing as far as possible
to the right and check that the choke is fully
actuated.
3. Tighten the clamping screw.
4. Pull back the throttle to the full throttle position
and check that the choke is no longer actuated.
8009-685
~ 10Nm
10mm
Inspecting the muffler
Check regularly that the muffler is complete and
secured correctly.
Temperature variations and vibrations can mean
that the tightening torque for the screws drops. The
screws should be checked when servicing to
guarantee the correct torque. The tightening torque
should be about 10 Nm. Never use a defective
muffler.
WARNING!!
The muffler gets very hot in use
and remains so for a short time
afterwards. Contact can result in
burns. Remember the risk of fire.
8009-455
8009-469
8009-456