Manualshelf

Operators Manual

ManualsBrandsHusqvarna ManualsToolsRC 318T
11121314151617181920
Table Of Contents
Maintenance
Introduction
WARNING: Before you do any maintenance
work you must read and understand the
safety chapter.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an authorized service agent do the
maintenance.
Note: If more than one time interval is marked in the
table, the shortest time interval is for the first
maintenance only.
Maintenance Daily maintenance
before operation
Maintenance interval
in hours
25 50 100 200
Make sure that nuts and screws are tightened *
Make sure that there are no fuel or oil leaks *
Clean as given in
To clean the product on page 20
X
Clean under the cutting deck X
Clean around the muffler X
Make sure that the engine cooling air intake is not blocked X
Make sure that the hydraulic oil cooler is not blocked, RC 320Ts
AWD
model only
X
Make sure that the safety devices are not defective X
Examine and test the brakes *
Make sure that the sensor for collector full works correctly X
Do a check of the engine oil level X
Do a check of the oil level in the transmission X
Do a check of the steering wires X
Examine the blades in the cutting deck X
Clean the cutting deck, under the belt covers and under the cutting
deck
X
Examine the headlights X X
Make sure that the tire pressure is correct X X
Do a check of the parking brake X
Change the engine oil X X
Change the oil filter X X
Clean the air filter X
Change the air filter X
Change the fuel filter X
Clean around the sensor for collector full X
368 - 004 - 19