User manual

Remove all packaging before positioning the machine.
If possible, position the machine next to a water tap and a drain.
Building-in
This dishwasher is designed to be fitted under a kitchen counter or work surface.
It is essential that the recess dimensions indica-
ted in the illustration are followed.
The height of the recess where the dishwasher is
to be installed can vary between 820 and 880
mm from the floor since the dishwasher is fitted
with adjustable feet (max. 60 mm).
No further openings for the venting of the dish-
washer are required, but only to let the water fill
and drain hose and power supply cable pass
through.
Leave a space of 2 mm between the top of the
dishwasher and the underside of the kitchen
counter.
During all operations that involve accessibility to
internal components the dishwasher has to be
unplugged.
When inserting the machine, ensure that the water inlet hose, the drain hose and the supply
cable are not kinked or squashed.
Adjusting the height of the dishwasher
To adjust the height proceed as follows:
1. Loosen or tighten the two front feet.
2. Loosen and remove the adjustable plinth.
3. Adjust the rear foot by turning the screw in the middle of the front kick plate to the
left or to the right. Good levelling is essential for correct closure and sealing of the
door.
When the appliance is correctly levelled, the door will not catch on the levelling spacers on
either side of the cabinet. If the door does not close properly, loosen or tighten the ad-
justable feet until the machine is perfectly level.
28
Installation