Lawn Mower User Manual

Driving

5. Set the desired engine speed (even idle) using the throttle

control.

Allow the engine to run at a moderate speed, for

3-5 minutes before loading it heavily.

Starting in cold conditions

If the engine does not start due to cold conditions,

repeat glow plug heating and try starting again.

Start gas or ether must not be used.

Starting with a weak battery

If the battery is too weak to start the engine, it should

be recharged.

If jump leads are used for emergency starting, follow

the procedure below:

Connecting jump leads:

• Connect each end of the RED lead to the

POSITIVE terminal (+) on each battery, and take

care not to short-circuit an end against the chassis.

• Connect one end of the BLACK lead to the

NEGATIVE terminal (-) on the battery that is fully

charged.

WARNING:

IMPORTANT INFORMATION:

Never run the engine indoors, in enclosed or badly

ventilated areas. Engine exhaust fumes contain

poisonous carbon monoxide and carcinogenic

substances.

Engine speed control in idling mode

Start gas or ether must not be used

Lead-acid batteries produce explosive gases. Avoid

sparks, open ﬂames and smoking close to batteries.

Always wear protective glasses in the vicinity of

batteries.

Your Rider is equipped with a 12-volt system with

negative earth. The other vehicle must also have a 12-

volt system with negative earth. Do not use your lawn

mower battery to start other vehicles.

Jump starting