User's Manual

Torque Specifications

· Engine crankshaft bolt 67 Nm(50 ft/lb)

· Deck pulley bolts 61 Nm (45 ft/lb)

· Hydraulic tube nuts 41 Nm (30 ft/lb)

· Wheel motor hub nut 122 Nm (90 ft/lb)

· Lug nuts 100 Nm (75 ft/lb)

· Blade bolt 122 Nm (90 ft/lb)

· Standard ¼” fasteners 12 Nm (9 ft/lb)

· Standard 5/16” fasteners 25 Nm (18 ft/lb)

· Standard 3/8” fasteners 44 Nm (33 ft/lb)

· Standard 7/16” fasteners

(seat belt) 70 Nm (52 ft/lb)

· Standard ½” fasteners

(roll bar) 110 Nm (80 ft/lb)

MAINTENANCE

Winter storage

To prepare the machine for storage. Clean the

machine, especialy under the deck. Touch-up the

paint or spray the underside of deck with a light

coat of oil.

Inspect the machine for damage and loose hard-

ware.

Change the oil.

Drain the fuel system or add stabilizer to fuel. Make

sure to run the machine after to circulate stabilizer

throughout system.

Remove the plugs and add 1 tablespoon of oil in

each cylinder. Install plugs and crank the engine

two or three revolutions.

Grease all zerks.

Remove battery and store inside and protect it from

freezing temperatures.