Tiller User Manual

15
SERVICE AND ADJUSTMENTS
belts 10
BELT GUIDE
REVERSE
IDLER PULLEY
BELT GUIDE
TRANSMISSION PULLEY
FORWARD IDLER PULLEY
REVERSE
IDLER PULLEY
IDLER
ARM PIN
ENGINE
PULLEY
FRONT VIEW REFERENCE
REVERSE (OUTSIDE) V-BELT
FORWARD MOTION (INSIDE) V-BELT
ENGINE PULLEY
REVERSE
IDLER
PULLEY
ENGINE PULLEY
FORWARD
IDLER PULLEY
Fig. 22
FORWARD MOTION
(INSIDE) V-BELT
ENGINE PULLEY
REVERSE IDLER ARM
REVERSE
IDLER PULLEY
IDLER
ARM PIN
BELT
GUARD
BOLT
TRANSMISSION
PULLEY
Fig. 21
FORWARD IDLER PULLEY
BELT GUIDE
REVERSE (OUTSIDE) V-BELT
CHECK TINE OPERATION
• See “TINE OPERATION CHECK” in this section of
manual.
REPLACE BELT GUARD
ENGINE
Maintenance, repair, or replacement of the emission control
devices and systems, which are being done at the cus tom-
ers expense, may be performed by any non-road engine
repair establishment or individual. Warranty repairs must
be performed by an authorized engine manufacturer's
service outlet.
TO ADJUST CARBURETOR
The carburetor has been preset at the factory and ad just ment
should not be necessary. However, engine per for mance
can be affected by dif fer enc es in fuel, tem per a ture, al ti tude
or load. If the carburetor does need ad just ment, contact
your nearest authorized service center/de part ment
IMPORTANT: NEVER TAMPER WITH THE ENGINE
GOVERNOR, WHICH IS FACTORY SET FOR PROPER ENGINE
SPEED. OVERSPEEDING THE ENGINE ABOVE THE FACTORY
HIGH SPEED SETTING CAN BE DANGEROUS. IF YOU THINK
THE ENGINE-GOVERNED HIGH SPEED NEEDS ADJUSTING,
CONTACT YOUR NEAREST AUTHORIZED SERVICE CENTER/
DEPARTMENT, WHICH HAS THE PROPER EQUIPMENT AND
EXPERIENCE TO MAKE ANY NECESSARY ADJUSTMENTS.