Chainsaw User Manual

ASSEMBLY

18 – English

spanner with a shaft that is long enough to allow this. The

arrow in the diagram shows the area where you should

operate the socket spanner when loosening or tightening

the nut.

Fitting the trimmer guard and

trimmer head Trimmy SII

• Fit the correct trimmer guard (A) for use with the

trimmer head. Hang the trimmer guard/combination

guard (A) on the two hooks on the plate holder (M).

Bend the guard around the shaft and tighten it with the

bolt (L) on the opposite side of the shaft. Use the

locking pin (C). Place the locking pin in the groove on

the screw head and tighten. See diagram.

• Fit the drive disc (B) on the output shaft.

• Centre the metal cup (P) on the drive disc’s blade

guide.

• Turn the blade shaft until one of the holes in the drive

disc aligns with the corresponding hole in the gear

housing.

• Insert the locking pin (C) in the hole to lock the shaft.

• Screw on the trimmer head (H) in the opposite

direction to the direction of rotation.

• Tighten the trimmer head to a torque of 35-50 Nm

(3.5-5 kpm).

• To dismantle, follow the instructions in the reverse

order.

Fitting other guards and cutting

attachments

• Fit the trimmer guard/combination guard (A) intended

for use with the trimmer head/plastic blades. Hang the

trimmer guard/combination guard (A) on the two

hooks on the plate holder (M). Bend the guard around

the shaft and tighten it with the bolt (L) on the opposite

side of the shaft. Use the locking pin (C). Place the

locking pin in the groove on the screw head and