User's Manual

English – 23

STARTER

WARNING!

• The return spring is under tension when in its cassette

in the starter and can, with careless handing, fly out

and cause personal injury.

• Care must be exercised when replacing the recoil

spring or the starter cord. Wear protective glasses.

Dismantling

1. Undo the four bolts holding the starter (A) and air conductor

(B) in position.

4. Carefully lift up the spring cassette so that the spring does

not fly out and cause personal injury.

5. If the starter cord is to be replaced, cut it off and pull out the

pieces from the handle and starter pulley using a pair of

long nosed pliers.

2. Pull the cord out 20-30 cm and lift it into the cut-out on the

starter pulley’s outer edge. Release the tension on the

return spring by allowing the starter pulley to rotate slowly

backwards.

3. Undo the centre bolt and take out the washer and starter

pulley.