User's Manual

GB - 16
CHECK DRIVE BELT
Check drive belt for wear or damage. Replace
belt if worn or damaged. See Service and
Adjustments.
CHECK ENGINE/BLADE
CONTROL
The engine/blade control must stop the engine
and blade within 3 seconds after the bail is
released. If the engine or blade continues to
run, adjust or repair control immediately. See
Adjustments.
CHECK GRASS BAG
Check bag for wear or damage. Keep bag
clean and dry. Replace only with Husqvarna
original equipment replacement bag.
CHECK DRIVE CONTROL (Self
propelled units)
Check operation of drive control. The drive
must disengage completely when the bail
handle is released. Adjust bail travel if
necessary. See Adjustments.
GENERAL LUBRICATION
Mower does not require any lubrication. Wheel
assemblies are designed for long life without
additional lubrication.
NOTE: The 600C does have lube fittings on
drive mount for use in commercial
applications. Lubricate as needed.
Swivel Lubrication (swivel units)
See Figure 12.
When lubricating for the first time, clean all
components thoroughly before applying
grease. Reapply grease to the lube fittings
every 25 hours.
NOTE: Linchpin must be in the swivel lock
hole while lubricating.
CHECK FASTENERS
Check all fasteners for proper tightness. Pay
special attention to blade hardware and all
guards, shields and safety devices.
CHECK SPARK PLUG
Spark plug should be cleaned (or replaced) if
necessary and gap reset to .030" every 100
hours of operation or yearly, whichever comes
first.
To clean:
1. Remove debris from area around spark
plug base.
2. Remove spark plug from engine.
3. Scrape and wash spark plug with a
commercial solvent. DO NOT blast
clean.
4. Replace spark plug.
NOTE: Sparking can occur if wire terminal
does not fit firmly on spark plug. Replace
terminal if damaged.
1. Blade
2. Cap Screw, Lock
Washer & Flat Washer
3. Drive Belt
4. Idler
1
2
3
4
OM0250
Figure 11
1. Grease Fitting
2. Swivel Lock Hole
1
2
OM0180
Figure 12