Operators Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Assembly
- Introduction
- To assemble the throttle handle
- To assemble the handlebar
- To assemble the handlebar
- To assemble the cutting equipment
- To attach the trimmer guard or combination guard for trimmer head and plastic blades
- To attach a trimmer head or plastic blade
- To attach the guard extension
- To remove the guard extension
- To attach the grass blade and the grass blade guard/combination guard
- To install the saw blade
- To install the blade guard
- To adjust the harness
- Quick release function of the harness
- Operation
- Introduction
- Before you operate the product
- Fuel
- Work position
- Correct balance of the product
- To prepare the product for start
- To start the product
- To start with a throttle handle with a start throttle lock
- To stop the product
- Blade thrust
- General work instructions
- Forestry clearing with a saw blade
- Brush cutting with a saw blade
- Grass clearing with a grass blade
- Grass trimming with a trimmer head
- Maintenance
- Introduction
- Maintenance schedule
- To clean the cooling system
- To do a check of the muffler
- Air filter
- To clean the air filter
- To apply oil to the air filter
- Bevel gear
- To attach and remove the locknut
- To examine the spark plug
- To adjust the engine
- To adjust the low speed needle (L)
- To adjust the high speed needle (H)
- To adjust the start throttle speed
- To adjust the idle speed
- To sharpen the grass knife and grass blade
- To sharpen the saw blade
- Troubleshooting
- Transportation, storage and disposal
- Technical data
- Accessories
- EC Declaration of Conformity
To do a check of the vibration damping system
WARNING: An incorrectly wound cord or an
incorrect cutting attachment increases the
level of vibration. Refer to
Safety instructions
for operation on page 4
.
The vibration damping system decreases vibration in the
handles to a minimum which makes the operation
easier.
1. Stop the engine.
2.
Do a visual check for deformation and damage.
3. Make sure that the vibration damping units are
correctly attached.
To do a check of the quick-release mechanism
WARNING: Do not use a harness with a
defective quick-release mechanism.
The quick-release mechanism lets the operator remove
the product quickly from the harness if there is an
emergency.
1.
Stop the engine.
2. Do a visual check for damage for example, cracks.
3.
Release and attach the quick-release mechanism to
make sure that it operates correctly.
To do a check of the muffler
WARNING: Do not use a product with a
defective muffler.
WARNING: The muffler becomes very hot
during and after operation and also at idle
speed. Use protective gloves to prevent
burn injuries.
The muffler keeps noise levels to a minimum and points
exhaust fumes away from the operator.
1.
Stop the engine.
2. Do a visual check for damage and deformation.
Note: The inner surfaces of the muffler contain
chemicals that can cause cancer. Be careful not to
touch these elements if the muffler is damaged.
3. Make sure that the muffler is correctly attached to
the product.
8 1069 - 005 -