Operators Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Assembly
- Introduction
- To assemble the throttle handle
- To assemble the handlebar
- To assemble the handlebar
- To assemble the cutting equipment
- To attach the trimmer guard or combination guard for trimmer head and plastic blades
- To attach a trimmer head or plastic blade
- To attach the guard extension
- To remove the guard extension
- To attach the grass blade and the grass blade guard/combination guard
- To install the saw blade
- To install the blade guard
- To adjust the harness
- Quick release function of the harness
- Operation
- Introduction
- Before you operate the product
- Fuel
- Work position
- Correct balance of the product
- To prepare the product for start
- To start the product
- To start with a throttle handle with a start throttle lock
- To stop the product
- Blade thrust
- General work instructions
- Forestry clearing with a saw blade
- Brush cutting with a saw blade
- Grass clearing with a grass blade
- Grass trimming with a trimmer head
- Maintenance
- Introduction
- Maintenance schedule
- To clean the cooling system
- To do a check of the muffler
- Air filter
- To clean the air filter
- To apply oil to the air filter
- Bevel gear
- To attach and remove the locknut
- To examine the spark plug
- To adjust the engine
- To adjust the low speed needle (L)
- To adjust the high speed needle (H)
- To adjust the start throttle speed
- To adjust the idle speed
- To sharpen the grass knife and grass blade
- To sharpen the saw blade
- Troubleshooting
- Transportation, storage and disposal
- Technical data
- Accessories
- EC Declaration of Conformity
2. Push down the throttle trigger lockout and make sure
that it goes back to its initial position when you
release it.
3. Make sure that the throttle trigger is locked at the
idle position when the throttle trigger lockout is
released.
4. Start the product and apply full throttle.
5. Release the throttle trigger and make sure that the
blades stop and stay stationary.
WARNING: If the blades move when the
throttle trigger is in the idle position, then
the carburetor idle speed must be
adjusted. Refer to
To adjust the idle
speed on page 25
.
Stop switch
Start the engine. Make sure that the engine stops when
you move the stop switch to the stop position.
To do a check of the cutting attachment guard
WARNING: An incorrect or defective cutting
attachment guard can cause serious injury.
Refer to
Safety instructions for operation on
page 4
.
WARNING: Always use the recommended
cutting attachment guard for the cutting
attachment that you use. If an incorrect or
defective cutting attachment guard is
installed, this can cause serious injury. Refer
to
Technical data on page 28
.
The cutting attachment guard prevents injuries from
objects that eject in the direction of the operator. It also
prevents injuries that occur if you touch the cutting
attachment.
1.
Do a visual check for damages, for example cracks.
2. Replace the cutting attachment guard if it is
damaged.
1069 - 005 - 7