Operators Manual
Table Of Contents
- Contents
- Introduction
- Safety
- Assembly
- Introduction
- To assemble the throttle handle
- To assemble the handlebar
- To assemble the handlebar
- To assemble the cutting equipment
- To attach the trimmer guard or combination guard for trimmer head and plastic blades
- To attach a trimmer head or plastic blade
- To attach the guard extension
- To remove the guard extension
- To attach the grass blade and the grass blade guard/combination guard
- To install the saw blade
- To install the blade guard
- To adjust the harness
- Quick release function of the harness
- Operation
- Introduction
- Before you operate the product
- Fuel
- Work position
- Correct balance of the product
- To prepare the product for start
- To start the product
- To start with a throttle handle with a start throttle lock
- To stop the product
- Blade thrust
- General work instructions
- Forestry clearing with a saw blade
- Brush cutting with a saw blade
- Grass clearing with a grass blade
- Grass trimming with a trimmer head
- Maintenance
- Introduction
- Maintenance schedule
- To clean the cooling system
- To do a check of the muffler
- Air filter
- To clean the air filter
- To apply oil to the air filter
- Bevel gear
- To attach and remove the locknut
- To examine the spark plug
- To adjust the engine
- To adjust the low speed needle (L)
- To adjust the high speed needle (H)
- To adjust the start throttle speed
- To adjust the idle speed
- To sharpen the grass knife and grass blade
- To sharpen the saw blade
- Troubleshooting
- Transportation, storage and disposal
- Technical data
- Accessories
- EC Declaration of Conformity
Check Possible cause Procedure
Fuel tank. Incorrect fuel type. Drain the fuel tank and fill with cor-
rect fuel.
Spark plug. The spark plug is dirty or wet. Make sure that the spark plug is dry
and clean.
The spark plug electrode gap is in-
correct.
Clean the spark plug. Make sure that
the electrode gap is correct. Make
sure that the spark plug has a su-
pressor.
Refer to technical data for correct
electrode gap.
The spark plug is loose. Tighten the spark plug.
The engine starts but stops again
Check Possible cause Procedure
Fuel tank Incorrect fuel type. Empty the fuel tank and fill it with correct fuel.
Air filter The air filter is clogged. Clean the air filter.
Transportation, storage and disposal
Transportation and storage
•
Store and transport the product and fuel so that
there is no risk that any leakage or fumes comes in
contact with sparks or open flames, for example,
from electrical machinery, electric motors, electrical
relays/switches or boilers.
• When you store and transport fuel always use
approved containers intended for this purpose.
• When you store the product for long periods the fuel
tank must be emptied. Contact your local petrol
station to find out where to dispose excess fuel.
Drain the tank into the appropriate containers and in
a well ventilated area.
• Ensure that the product is cleaned and that a
complete service is carried out before long-term
storage.
• The transport guard must always be fitted to the
cutting attachment when the product is transported
or in storage.
• Secure the product during transport.
•
In order to prevent unintentional start of the engine,
the spark plug cap must always be removed during
long-term storage if the product is not under close
supervision and when you perform all service
measures.
• Allow the product to cool before you put in storage.
Disposal
• Obey the local recycling requirements and applicable
regulations.
• Discard all chemicals, such as engine oil or fuel, at a
service center or at an applicable disposal location.
• When the product is no longer in use, send it to a
Husqvarna dealer or discard it at a recycling
location.
1069 - 005 - 27